Advances in rapid and effective break-in/conditioning/recovery of automotive PEMFC stacks

Automotive proton exchange membrane fuel cell stacks need to meet manufacturer specified rated beginning-of-life (BOL) performance before being assembled into vehicles and shipped off to customers. The process of “breaking-in” of a freshly assembled stack is often referred to as “conditioning.” It has become an intensely researched area especially in automotive companies, where imminent commercialization of fuel cell electric vehicles (FCEVs) demands a short, energy- and cost-efficient, and practical conditioning protocol. Significant advances in reducing the conditioning time from 1 to 2 days to as low as 4h or less, in some cases without the use of additional inert gases such as nitrogen, and with minimal use of hydrogen, and specialized test stations will be discussed.     

发动机机油滤清器虑层强度分析及优化

针对机油滤清器工作工况下进出口压差、机油滤层强度及导流桩高度等问题, 通过试验测试与仿真相结合, 对滤清器初步设计进行了评估及优化, 以确保滤清器在工作工况下进出口压降及滤层强度能满足要求. 首先进行滤层性能试验, 得到滤层的惯性阻力系数和黏性阻力系数; 再通过滤层多孔介质CFD分析, 对滤清器进出口压降进行分析计算. 结果表明: 在-18℃、25℃和70℃的工况下, 进出口压降都小于10kPa, 满足相关要求. 针对滤层的最大主应力超过其抗拉强度的问题, 通过CAE仿真分析, 优化滤层与导流桩间隙, 将滤层最大主应力由110.1MPa降至36.99MPa, 小于其抗拉强度42.8MPa.     

Bifurcation analysis of visual angle model with anticipated time and stabilizing driving behavior

In the light of the visual angle model (VAM), an improved car-following model considering driver's visual angle, anticipated time and stabilizing driving behavior is proposed so as to investigate how the driver's behavior factors affect the stability of the traffic flow. Based on the model, linear stability analysis is performed together with bifurcation analysis, whose corresponding stability condition is highly fit to the results of the linear analysis. Furthermore, the time-dependent Ginzburg-Landau (TDGL) equation and the modified Korteweg-de Vries (mKdV) equation are derived by nonlinear analysis, and we obtain the relationship of the two equations through the comparison. Finally, parameter calibration and numerical simulation are conducted to verify the validity of the theoretical analysis, whose results are highly consistent with the theoretical analysis.     

Enhanced Power Density of Alcohol Biofuel Cell by Polymer-assisted Crosslinks of 3D Graphene on Carbon Paper as the Bioanode

Herein, we successfully construct the 3D biocompatible graphene through crosslinking 2D graphene nanosheet onto carbon fiber paper with poly(diallyldimethylammonium chloride) (PDDA) as anode of the alcohol biofuel cell. Compared with the bioanode without 3D graphene, the current density and output power of PDDA-graphene-ADH bioanode is increased by 23 % and 41 % at a high concentration of ethanol at pH 8.9, suggesting the stabilization role of graphene in enzyme loading. The study provides us a deep analysis on structures and performances of the bioanode incl. electrochemistry, X-ray photoelectron spectra, and atomic force microscopy images, which is significant to develop the new methods to construct 3D porous electrodes in energy conversion device.     

桉树杂交种与其亲本的近红外光谱判别

研究桉树控制授粉后目标性状的基因作用方式是探索其基因重组规律的重要内容。常规的数量统计分析精度往往不高,而DNA分析的专业要求高,且费时费力。该研究利用近红外光谱(NIRs)研究不同基因型桉树杂交种、亲本及杂交种与亲本间近红外光谱信息的关系,探索NIRs用于桉树杂交种与其亲本判别的可行性和准确性。以控制授粉的桉树亲本及其杂交F1代材料为对象,每种基因型从各自田间试验分别选取10个单株,采集树冠中上部新鲜健康叶片。用手持式近红外仪Phazir Rx(1624)采集桉树杂交种与其亲本叶片的NIRs信息。每单株选10片完全生理成熟的健康叶片,避开叶脉扫描其正面光谱5次,以50条NIRs信息的均值代表单个叶片的NIRs信息,最终每个基因型获得10条NIRs信息。对原始NIRs采用二阶多项式S.G一阶导数预处理。预处理后的NIRs用于多元统计分析,首先对桉树杂交亲本和子代样本进行主成分分析(PCA),直观展示不同基因型的分类情况。然后运用簇类独立软模式(SIMCA)和偏最小二乘判别分析(PLS-DA)两种有监督的判别模式验证NIRs用于桉树杂交种与其亲本树种的分类判别效果。PCA结果显示,不同的亲本间、杂交种间及杂交种与亲本间样本的主因子得分可以清晰地将各基因型分开。SIMCA模式判别分析中,桉树杂交种样本到亲本PCA模型的样本距离显示,待判别样本能够形成单独的聚类,且能直观反映两者的遗传相似。PLS-DA判别结果显示,桉树杂交亲本的PLS模型能通过预测其杂交子代的响应变量将其与亲本准确分开。结果表明,桉树叶片的NIRs信息可以准确地反映桉树杂交子代遗传信息的传递规律,NIRs判别模型可以准确地将各种基因型予以区分。因此,NIRs信息不仅可用于桉树杂交种和纯种的定性判别,还可以分析桉树基因重组过程中加性遗传效应的大小,从而为桉树遗传基础分析及其育种改良研究提供理论支撑。     

Edge-enriched graphene with boron and nitrogen co-doping for enhanced oxygen reduction reaction

Carbon-based electrocatalysts for oxygen reduction reaction (ORR), especially in anion exchange membrane fuel cells (AEMFCs), have received a lot of attention because they exhibit excellent stability and are comparable to commercial Pt/C catalysts. Currently, to maximize the catalytic activity of carbon-based electrocatalysts, there are two major strategies: heteroatom doping or exposing active edge sites. However, the approach of increasing heteroatomic dopants of active edge sites has been rarely addressed. In this study, we present a simple strategy to prepare edge-enriched graphene catalysts with an increased ratio of heteroatomic dopants suitable for ORR of AEMFCs. The catalysts were prepared under harsh oxidation conditions, followed by a simple co-doping process with boron and nitrogen. The ORR activity of the catalysts was observed to be related to an increase of edge sites with heteroatomic dopants. We believe that the edge-enriched structure leads to accelerated electron transfer with enhanced oxygen adsorption.     

A probabilistic approach to spectral analysis of growth-fragmentation equations

The growth-fragmentation equation describes a system of growing and dividing particles, and arises in models of cell division, protein polymerisation and even telecommunications protocols. Several important questions about the equation concern the asymptotic behaviour of solutions at large times: at what rate do they converge to zero or infinity, and what does the asymptotic profile of the solutions look like? Does the rescaled solution converge to its asymptotic profile at an exponential speed? These questions have traditionally been studied using analytic techniques such as entropy methods or splitting of operators. In this work, we present a probabilistic approach: we use a Feynman–Kac formula to relate the solution of the growth-fragmentation equation to the semigroup of a Markov process, and characterise the rate of decay or growth in terms of this process. We then identify the Malthus exponent and the asymptotic profile in terms of a related Markov process, and give a spectral interpretation in terms of the growth-fragmentation operator and its dual.     

Mass distribution and skewness for passive scalar transport in pipes with polygonal and smooth cross sections

We extend our previous results characterizing the loading properties of a diffusing passive scalar advected by a laminar shear flow in ducts and channels to more general cross‐sectional shapes, including regular polygons and smoothed corner ducts originating from deformations of ellipses. For the case of the triangle and localized, cross‐wise uniform initial distributions, short‐time skewness is calculated exactly to be positive, while long‐time asymptotics shows it to be negative. Monte Carlo simulations confirm these predictions, and document the timescale for sign change. The equilateral triangle appears to be the only regular polygon with this property—all others possess positive skewness at all times. Alternatively, closed‐form flow solutions can be constructed for smooth deformations of ellipses, and illustrate how both nonzero short‐time skewness and the possibility of multiple sign switching in time is unrelated to domain corners. Exact conditions relating the median and the skewness to the mean are developed which guarantee when the sign for the skewness implies front (more mass to the right of the mean) or back (more mass to the left of the mean) “loading” properties of the evolving tracer distribution along the pipe. Short‐ and long‐time asymptotics confirm this condition, and Monte Carlo simulations verify this at all times. The simulations are also used to examine the role of corners and boundaries on the distribution for short‐time evolution of point source , as opposed to cross‐wise uniform, initial data.     

Feasibility of application of conductometric biosensor based on acetylcholinesterase for the inhibitory analysis of toxic compounds of different nature

This study was aimed at the development of a conductometric biosensor based on acetylcholinesterase considering the feasibility of its application for the inhibitory analysis of various toxicants. In this paper, the optimum conditions for enzyme immobilization on the transducer surface are selected as well as the optimum concentration of substrate for inhibitory analysis. Sensitivity of the developed biosensor to different classes of toxic compounds (organophosphorus pesticides, heavy metal ions, surfactants, aflatoxin, glycoalkaloids) was tested. It is shown that the developed biosensor can be successfully used for the analysis of pesticides and mycotoxins, as well as for determination of total toxicity of the samples. A new method of biosensor analysis of toxic substances of different classes in complex multicomponent aqueous samples is proposed.